Troubleshooting; Optional Accessories - Makita DUR187U Instruction Manual

TROUBLESHOOTING

ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
Cutting tool and motor cannot stop:
Remove the battery immediately!
OPTIONAL
ACCESSORIES
WARNING:
Do not mount a metal blade on
this tool and only use the recommended accesso-
ries or attachments indicated in this manual. The
use of a metal blade or any other accessory or attach-
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
accessories or attachments might present a risk of
for its stated purpose.
If you need any assistance for more details regarding
NOTE:
tool package as standard accessories. They may
differ from country to country.
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
nylon cutting head.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The drive system does not work
correctly.
The use of any other
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Recharge the battery. If recharging is not effective,
replace battery.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Tap the nylon cutting head against the ground while
it is rotating to cause the cord to feed.
service center for repair.
18 ENGLISH
-