Operation - Gardena PowerCut Li-40/30 Operator's Manual

To assemble the additional
handle:
g

3. OPERATION

To charge the battery:
ß
A
ß
B
ß
D
ß
M
ß
Lc
ß
Wc
ß
C
18
1. Slide the additional handle
hard against the rivet).
Make sure that the handle is firmly located.
q
2. Tighten the screw
h
DANGER! Risk of injury!
Cut injury when the trimmer starts accidentally.
v Wait for the cutting filament to stop and remove the
battery before you adjust or transport the trimmer.
CAUTION!
Overvoltage damages the battery and the battery
charger.
v Make sure that you use the correct mains voltage.
For the GARDENA Battery Trimmer Art. 9827-55 there is
no battery in the scope of delivery.
Before you use the battery the first time, the battery must be com-
pletely charged.
The lithium-ion battery can be charged in any state of charge and
the charging process can be disconnected at any time without to
damage the battery (no memory effect).
1. Push both locking buttons
battery holder
2. Connect the mains cable
3. Connect the mains cable
4. Connect the battery charger cable
When the charging control lamp
green once per second the battery is being charged.
When the charging control lamp
ß
B
green the battery is completely charged
(Charging time, see 7. TECHNICAL DATA).
5. Examine the charge status regularly while you charge.
6. When the battery
ß
battery
B
7. Disconnect the charger
ß
E
q
into the rivet
h
.
ß
and remove the battery
A
ß
.
D
ß
to the charger
M
ß
to a 230 V mains socket.
M
ß
ß
ß
is completely charged, disconnect the
B
ß
from the charger .
C
ß
from the mains.
C
g
(Do not push very
ß
from the
B
ß
.
C
ß ß
to the battery .
E B
at the charger flashes
Lc
at the charger illuminates
Lc