Maintenance - Gardena PowerCut Li-40/30 Operator's Manual

To extend the cutting filament
(Tip mechanism):
4

4. MAINTENANCE

To clean the Trimmer:
To clean the battery and the
battery charger:
The tip mechanism operates when the motor operates.
The best result occurs only with the maximum cutting filament length.
During first operation, it can be necessary to extend the cutting fila-
ment many times.
1. Start the product.
2. Hold the trimmer head
tap onto a solid surface (avoid constant pressure for extended
periods).
The cutting filament
that can be heard and adjusted to the correct length with the filament
r t
limiter . If necessary tap many times again and again.
t
r
DANGER! Risk of injury!
Cut injury when the trimmer starts accidentally.
v Wait for the cutting filament to stop and remove the
battery before you maintain the trimmer.
DANGER! Risk of injury!
Risk of injury and risk of damage to the trimmer.
v Do not clean the product with water or with a water jet
(in particular high-pressure water jet).
v Do not clean with chemicals including petrol or solvents.
Some can destroy critical plastic parts.
z
The airflow slots must always be clean.
1. Clean the airflow slots
driver).
2. Clean all movable parts after each operation. Especially remove
any grass and dirt from the protective cover
3
Make sure that the surface and the contacts of the battery and
the battery charger always are clean and dry before you connect the
battery charger.
Do not use running water.
v Clean the contacts and the plastic parts with a soft and dry cloth.
4
parallel to the ground and shortly
r
is automatically extended with a mechanism
z
with a soft brush (do not use a screw-
3
.
21