Area (Square Footage) Measurement; Volume (Cubic Feet) Measurement - Bosch GLM 42 Operating/Safety Instructions Manual

As you continue to take measurements, this cycle will
continue. The unit can display up to 3 previous mea-
surements.
The last three measurements will display on the mea-
sured-value lines c and the current measurement will
display on the result line d.

Area (Square Footage) Measurement

For area measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indica-
tor for area measurement
pears in the status bar. Select area measurement by
pressing the measure button 2 [ ]. Activate the laser
by pressing the measure button 2 [ ]. The laser will
be switched on.
0.0º
35.908ft
be calculated and display on the result line d.

Volume (Cubic Feet) Measurement

For volume measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for volume measurement
appears in the status bar. Select volume measurement
by pressing the measure button 2 [ ]. Activate the la-
ser by pressing the measure button 2 [ ]. The laser
will be switched on.
2610051599 03-18 GLM42.indd 19
Aim and press the measure button
2 [ ] again to take the measurement
for length which will appear on the
4'02"
⁄
L
top line of the measured-value lines c.
W 16'11"
Aim and press the measure button
2 [ ] again to take the measurement
2 for width which will appear on the
middle line of the measured-value
lines c and the area will automatically
and the word "Area" ap-
and the word "Volume"
-19-
3/23/18 9:52 AM