Trip; Functions Of Trip Meter - Hitachi Zaxis 33U-5A Operator's Manual

Trip

Functions of Trip Meter

The trip meter allows the operator to know that the
machine operation hour has reached the preset hour by
blinking the Trip mark (Trip 1 or Trip 2). The Trip mark blinks
for 30 seconds when the machine operation hour reaches
the preset hour. After that, every time the key switch is
turned ON, the Trip meter blinks for 30 seconds until the
meter is reset.
IMPORTANT: This "Operation Hour" means the machine
operation time counted from the point at which
the Trip meter is set. It is different from the "Total
Accumulated Machine Operation Time" displayed on
the hour meter.
f
NOTE: Once the Trip meter is set, it will continuously count
the machine operation time regardless of the LCD display (1)
status. When the machine operation hour reaches the preset
hours, the Trip mark on LCD display (1) blinks.
If Trip mark is displayed on the monitor screen when Trip mark
starts blinking, Trip mark stays ON after blinking. If Trip mark
is not displayed on the monitor screen when Trip mark starts
blinking, Trop mark goes OFF after blinking.
If Trip mark is not used, set sufficiently long time. (Example:
3000 h)
f
NOTE: The trip meter is set 9999.9h when the machine is
shipped from the factory.
OPERATOR'S STATION
Trip Mark
2
1-24
1
Trip Meter
MADB-01-047