Barco R9010310 Owner's Manual page 36

4. Connections
Lamp run time indication while running
When the total run time of the lamp is 30 hours less then maximum runtime, the following warning message will be displayed for 1
minute. This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
Remaining
Lamp run time
20h
Image 4-2
When the total run time of the lamp is maximum runtime hours or more, the following warning message, with the exact run time is
displayed on the screen.
WARNING
Lamp run time is x hours
operating the lamp longer
than x hours may damage
the projector.
Please replace the lamp
<ENTER> to continue
Menu 4-1
Lamp run time is maximum runtime hours. Operating the lamp longer than maximum runtime hours may damage the projector.
Please replace the lamp.
When ENTER is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is maximum runtime hours max. Do not use it longer. Always replace with a same
type of lamp. Call a BARCO authorized service technician for lamp replacement.
C
AUTION
Lamp Light Output Indication
When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be
displayed. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is X hours
The light output of the lamp
is less
than 50% of its initial value.
It is advisable to replace the
lamp
before damage occurs.
<ENTER> to confirm
Menu 4-2
When the 'Constant Light Output' (CLO) options is installed, the light output message will appear on the screen when the light output
is reduced with 33% from its initial value.
This message will be repeated every hour.
Lamp Z-axis indication
When starting up and the run time is 100 hours or 250 hours a Z-axis warning will be displayed. This warning will advise to adjust the
Z-axis of the lamp to obtain maximum light output. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is X hours.
It is advisable to
adjust the Z-axis
of the lamp to
obtain maximum
light output
(see owner's manual)
<ENTER> to confirm
Menu 4-3
32
:
Using a lamp for more than maximum runtime hours is dangerous as the lamp could explode.
R5976801 SLM R9+ 20/10/2004