Barco R9010310 Owner's Manual page 115

Proj 1
in out
RS
Terminator
Image 9-7
Principal diagram : linking via RS port
Linking via the Comm port
The constant light output of the projectors can be set to the same value by linking the projectors via the Comm port and using one
or more Comm 800 splitters (See Connections, Linked System).
Master Projector
Comm port
Comm 800 splitter
To slave 1 To slave 3
To slave 2
Image 9-8
Principal diagram: Linked via Comm port
For more information about the use of the Comm 800 splitter, consult the Comm 800 splitter documentation (R5976819).
Which information is available
serial number
type
run time
remaining run time
number of strikes
Z-AXIS
R5976801 SLM R9+ 20/10/2004
Proj 2 Proj 3
in in
out
RS
To next Comm 800 splitter
"To Switcher"
Comm 800 splitter
To slave 4
To slave 6
To slave 5
unique serial number of the lamp
lamp type
total time the lamp is used in this or other projectors.
time left before the lamp must be replaced Using the lamp longer than the maximum run time may
damage the projector.
Total times the lamp is started up.
indication to adjust the Z-AXIS of the lamp (see Re-adjustment of the lamp position in chapter
Installation Guidelines).
Proj 4
in
out
RS
To slave 7 or to
next Comm 800 splitter
"To Switcher"
9. Service Mode
111