Table of Contents
Advertisement
• External chimney flue entirely made up of insulated stainless steel pipes, i.e. with double wall of minimum Ø150
mm: all must be firmly attached to the wall. For chimney against wind effects please (see Fig. 4 page 7).
• Ducting system through T-unions which enables an easy cleaning without disassembling the pipes.
EN
9
FUEL
9.1
FUEL
• The allowed fuel is firewood and its derivatives (lignite blocks, compressed sawdust, etc.) with a maximum
water content of 20%.
• To obtain good firewood, it must be seasoned outside for at least 2 years in a place protected from the
weather.
• Using humid wood or waste bark could create condension and creosote into the ductions and in the hearth.
A heat yield of humid wood is great lower than dry wood.
To know the lenght of wood log to use, check the dimensions of stove combustion chamber.
It is advisable to place the wood in horizontal position (see Fig. 11 page 12) and adjust the air flow with the aid
of the register.
To ignite proper ignitier products can be used.
12
We recommend to check with your chimney flue manufacturer the safety distances which
must be respected and the type of insulating material. The aforesaid regulations are valid
also for holes made on the wall (EN 13501 - EN 13063 - EN 1856 - EN 1806 - EN 15827).
It is forbidden to use any type of liquid combustible!
It is forbidden to burn wood processing waste containing glue or paint, waste in general
and cardboard!
Fig. 10 - Wood positioning
CARINA - DORA
Advertisement
Table of Contents
