Radian RM-111 Operation Manual page 85

9. Make proper connections to the RM-111, see fi gure 19.0. Connect Pulse IN(s) to port(s) A, B,
and/or D and Pulse OUT to port D.
10. Set up the test board to test the solid state meter. Include all variables such as: form number,
volts, current, and number of pulses per revolution. If necessary, specify that a through-hole test
will be conducted.
11. Start the test on the test board. The RM-111 starts receiving pulses. After the specifi ed number
of pulses has been counted the RM-111 outputs one pulse. This continues until the RM-111's
CANCEL key is pressed.
12. The RM-111's display shows the pulses IN per the pulses OUT for as long as the test is ran.
For this application there are no results and therefore no save option.
84
Application 13 Application 13
RM-111 Operations Manual