Installation Instructions - SelectBlinds Cellular Push Button Cordless Honeycomb Shade Installation Instructions

Step 4: Level the Moving Rail (If Necessary)
If the bottom rail or the middle moving rail of a top down/bottom up
shade is not level, it can be adjusted by following the procedure below.
Remove the right endcap from the rail that is not level.
Pull out the section labeled TOOL.
Push in on the adjustment screw with the
tool and turn to adjust the rail.
When the rail is level, replace the tool and
the endcap.
Step 5: Hold Down Installation (optional)
Optional Hold Down Brackets are mounted with the supplied
screws. With the shade at its proper drop, place the pin of each
Hold Down into the hole in each End Cap and mark the screw holes.
Make sure the pins are level and aligned. Remove the pins from the
endcaps. Raise the shade, then screw the Hold Down Brackets into
the mounting surface. Lower the shade. Slightly flex the holddown
brackets to insert the pins into the endcaps.
Cleaning and Care
The Shade fabric is easy to care for. Regular dusting with a feather duster or
vacuum cleaner brush is recommended. Most stains can be blotted with a
damp sponge and mild detergent. Before using anything stronger than mild
detergent and lukewarm water, test an unobtrusive corner of the shade. If
you have any questions, call your dealer for advice.
152126 Rev C.
Cellular
Push Button Cordless
Top Down/
Bottom Up

Installation Instructions

Our window fashions represent a design breakthrough in
style, efficiency and function. Our Cellular shades feature
100% non-woven polyester fabric providing a soft diffused
light and high level of privacy. The unique hardware system
is designed to provide years of reliable service when properly
Please take a few minutes to read through
these instructions before beginning.
5/4/2015
Standard
installed.