Table of Contents
Advertisement
Quick Links
HONEYCOMB SHADES
STANDARD RECTANGULAR
CORDLESS LIFT & LOCK
Thank you for your purchase. This shade has been
custom built for you from the highest quality materials.
To avoid errors and save valuable time, please read
these instructions before installing your new shade.
1. Pencil or Marker
2. Measuring Tape
3. Needlenose Pliers
4. Phillips Screwdriver
5. Carpenter's Level
6. Power Drill
7. Mounting Fasteners
All the required installation components are wrapped in your package along with
these instructions. Check that the parts you have correspond to the parts shown
below. NOTE: Some parts may vary depending upon your chosen mounting options.
PARTS
Standard Installation Brackets ..................................................
Fabric-wrapped Rail Installation Brackets..........................................
Swivel Brackets (not all shades) ................................................
Extension Bracket (optional) ....................................................
Spacer Blocks (optional) .........................................................
Hold Down Brackets (optional) ..................................................
Cord Cleats .........................................................................
Screws ................................................................................
INSTALLATION INSTRUCTIONS
TOOLS YOU WILL NEED
GETTING STARTED
Advertisement
Table of Contents
Related Manuals for SelectBlinds STANDARD RECTANGULAR CORDLESS LIFT & LOCK HONEYCOMB SHADE
Summary of Contents for SelectBlinds STANDARD RECTANGULAR CORDLESS LIFT & LOCK HONEYCOMB SHADE
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS HONEYCOMB SHADES STANDARD RECTANGULAR CORDLESS LIFT & LOCK Thank you for your purchase. This shade has been custom built for you from the highest quality materials. To avoid errors and save valuable time, please read these instructions before installing your new shade. TOOLS YOU WILL NEED 1. -
Page 2: Step 1: Mounting The Brackets
STEP 1: MOUNTING THE BRACKETS Standard and fabric-wrapped rail installation brackets may be used for INSIDE or OUTSIDE mounts. Swivel brackets may be used for INSIDE mounts only. The ¾” brackets also accommodate ½” double cell fabric shades. Mounting the brackets level is essential for proper operation of the shade. Shim the brackets if necessary to achieve a level alignment. - Page 3 OUTSIDE MOUNTS: Outside Mount Surface Height Requirements Bracket Size Minimum Height 3/8” Bracket 5/8” 3/4” Bracket 1” Fabric-wrapped Rail Bracket 3/4” ATTACH THE BRACKETS: Screw brackets through two back holes to desired location. SPACER BLOCKS (optional): Spacer blocks will be attached to the end of each bracket. ...
- Page 4 STEP 2: INSTALLING THE SHADE MOUNT THE HEADRAIL – STANDARD BRACKETS: With the front (colored) side of the shade facing you … Tilt the headrail slightly backward to angle the front inside lip to the brackets. Rotate headrail upward to snap in it into place. ...
- Page 5 STEP 4: ADJUSTING THE SHADE Raise and lower the shade several times. If the length is incorrect or the bottomrail is not level, use the following steps to correct. BOTTOMRAIL SHADE ADJUSTMENT: Lift bottomrail on the side to be adjusted. This will take ...
-
Page 6: Cleaning Instructions
STEP 5: INSTALL REMAINING ITEMS ATTACH THE (optional) HOLD DOWN BRACKETS – OUSIDE MOUNTS (only): Lower the shade and place the hold down pins into the bottomrail end caps. Mark the hold down bracket locations on the mounting surface. ... -
Page 7: Warranty Information
WARRANTY INFORMATION Lifetime Limited Warranty covering our Custom Made Blinds We extend this lifetime limited warranty to the original purchaser. This warranty applies only to manually operated Custom Products properly installed in the window, door or interior area for which they were intended. Installation of the product must be in accordance with accompanying instructions. - Page 8 C8-20-4400•Rev 1/15...