Advertisement
Quick Links
INSTALLATION
Pressure range= 0 / 3mBar (0.0 / 30.0mmH20).
Maximum permissive pressure= 3mBar (30mmH20).
Operating temperature= 0 - 70°C
Waterproof= IP55
HP59
IN= Ambient air input (pressure +).
OUT= External air input (pressure -).
How to connect the line
Connect 230V line on terminals L-N. Protect supply with adequate fuse.
To obtain maximum precision of pressure control, place HP59/W in
vertical position.
As it company policy to continually improve the products the Manufacturers
reserve the right to make any modifications thereto without prior notice.
They cannot be held liable for any damage due to malfunction.
3x0.5mmq section, L.max = 3 mt
HPAL contacts connection:
Contact relays are free voltage,
max
4AMP
AC1,
fuses
protection are 4A T H=35A.
www.pola.it
HP59/W
Air pressure controller
MAIN SETTING (Run Mode).
PRESSURE SETTING
Press SET (key lamp flashes): this message will be
displayed instead of the ° Set temperature value
Set Pression (mm H2o).
Press + or - to modify, press SET to escape.
SL 3.0
Handbook
Example with Set.P = 3.0
Advertisement
Related Manuals for POLA HP59/W
Summary of Contents for POLA HP59/W
- Page 1 OUT= External air input (pressure -). protection are 4A T H=35A. How to connect the line Connect 230V line on terminals L-N. Protect supply with adequate fuse. To obtain maximum precision of pressure control, place HP59/W in vertical position. MAIN SETTING (Run Mode). PRESSURE SETTING Press SET (key lamp flashes): this message will be displayed instead of the °...
- Page 2 "HAND MODE" . COSt PROGRAMMING (System constants). In some start-up conditions may be useful to work in "hand" mode. These settings refer to the mode operation of the system and must be made on Power off the processor, press + key and keep it pressed giving power on: initial start-up.