Husqvarna 131R Operator's Manual page 6

2. Push the throttle trigger lockout (A) and make sure
that it goes back to its initial position when you
release it.
3. Push the throttle trigger (B) and make sure that it
goes back to its initial position when you release it.
Start the engine, and then apply full throttle. Release the
throttle trigger (B) and examine if the cutting attachment
stops. If the cutting attachment turns with the throttle in
the idle position, examine the idle adjustment screw of
the carburetor.
Stop switch
Start the engine. Make sure that the engine stops when
you move the stop switch to the stop position.
6
Cutting attachment guard
The cutting attachment guard prevents a loose object to
eject in the direction of the operator. The guard also
prevents the operator from accidentally touching the
cutting attachment.
Examine the cutting attachment guard for damage and
cracks. Replace if it is damaged or has cracks. Only use
the approved guard for the cutting attachment.
WARNING: Do not use a cutting attachment
without an approved guard. If an incorrect or
defective guard is installed, this can cause
damage to persons.
Harness quick release
WARNING: Do not use the harness if the
harness quick release (A) is defective. Make
sure that the harness quick release operates
correctly after you adjust the product and the
harness.
The harness quick release (A) is at the front of the
product. The harness straps must always stay at the
correct position. In an emergency, the harness quick
release helps you to safely release from the product.
A
527 - 004 - 23.05.2018