Husqvarna 131R Operator's Manual page 11

To attach the cutting attachment guard
and the trimmer head
1. Attach the guard (A) to the shaft and tighten with the
bolt (L). Make sure to use the correct guard for the
correct trimmer head.
A
M
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
4. Put the locking pin in the hole to lock the shaft. Put
"G" on the shaft.
5. Turn the trimmer head (H) counterclockwise.
6. To disassemble, do the reverse procedure.
To install the 2-teeth blade in the guard
1. Install the blade in the transport guard.
527 - 004 - 23.05.2018
H H
L
G
B B
M M L L
H
To adjust the harness
WARNING: Always attach this product to the
harness correctly. If not, you cannot control
the product safely and this can result in
injury to you or others. Do not use a harness
with a defective quick release.
WARNING: Use the harness quick release
function if you must release from the product
and the harness in an emergency situation.
1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the side straps until the weight is equally
applied across your shoulders.
4. Adjust the harness until the cutting attachment is
parallel to the ground.
5. Let the cutting attachment stay lightly on the ground.
Adjust the harness clamp to balance the product
correctly.
11