Husqvarna 131R Operator's Manual page 3

Brushcutters/clearing saws
Hide thumbs Also See for 131R:
Table of Contents

Advertisement

5. Handlebar clamp
6. Stop switch
7. Throttle trigger
8. Throttle trigger lockout
9. Suspension ring
10. Cylinder cover
11. Spark plug cap
12. Starter handle
13. Fuel tank
14. Choke control
15. Air filter cover
16. Handlebar
17. Clutch cover
18. Locking nut
19. Support cup
20. Support flange
21. Drive disc
22. Operator's manual
23. Transport guard
24. Socket spanner
25. Spanner
26. Locking pin
27. Harness
28. Air purge
29. Trimmer head
30. Allen key
31. 2-teeth blade
Symbols on the product
WARNING! This product is dangerous.
Injury or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Please read the operator's manual carefully
and make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
527 - 004 - 23.05.2018
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum of 15 m distance to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m
distance to persons and animals during
operation of the product.
Air purge bulb.
The direction to close the choke.
The direction to open the choke.
Keep all parts of your body away from the
hot surfaces.
Noise emission to the environment refer to
the European Community's Directive. The
emission of the product is specified in the
Technical data chapter and on the label.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week and
xxxxx is the serial number.
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
the product is incorrectly repaired.
the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
yyyywwxxxxx
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents