First Status Updated To Knx - IntesisBox HA-AC-KNX-16 User Manual

®
IntesisBox KNX - Haier A.C. (VRF line)

4.1.4 First Status Updated to KNX

This parameter defines how fast the status is updated to KNX. Depending on the value selected,
more or less priority will be assigned to this action. As there are so many parameters available,
it is important to consider carefully how to set this parameter.
If set to "ASAP", all status communication objects will send its value (if needed).
o
If set to "Slow", all status communication objects will send its value (if needed), but slower
o
than in the previous option (ASAP).
If set to "Super Slow", all status communication objects will send its value (if needed), but
o
slower than in the previous option (Slow).
4.1.5 Enable object "Error Code [2byte]"
This parameter shows/hides the Status_ Error Code communication object which shows the
indoor unit errors, if occurred, in numeric format.
If set to "Disabled" the object will not be shown.
o
If set to "Enabled" the Status_ Error Code [2byte signed value] object will appear.
o
• This object can be read and also sends the indoor unit error, if occurred, in
numeric format. If a "0" value is shown that means no error.
4.1.6 Enable object "Error Text Code [14byte]"
This parameter shows/hides the Status_ Error Text Code communication object which shows
the indoor unit errors, if occurred, in text format.
If set to "Disabled" the object will not be shown.
o
If set to "Enabled" the Status_ Error Text Code object will appear.
o
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox is a registred trademark of Intesis Software SLU
Figure 4.7 Parameter detail
43:
Figure 4.8 Communication object and parameter detail
44:
Figure 4.9 Communication object and parameter detail
User's manual r1.0 EN
URL http://www.intesisbox.com
email info@intesisbox.com
tel +34 938047134
10 / 31