Peecon Cargo Compact Series Operator's Manual page 31

● Couple the machine in keeping with the instructions and make sure that the connection is secured
properly!
● Be particularly carefully when coupling and uncoupling the machine or the tractor!
● Only work with machines if their protection is complete and intact and functions properly!
● Immediately repair any wear or damage to the paintwork before working with the machine again!
If the machine is still covered by warranty, always contact your dealer or the manufacturer before
making repairs.
● Every now and then, check the hydraulic hoses for damage. Damaged hoses must be replaced
immediately by hoses of the prescribed quality (SAE 100 R2A according to DIN 20022/2). Never try
to manually seal an oil leak on a running motor/engine. The oil might penetrate your skin and cause
blood poisoning!
NOTE! Pay attention to these points when first installing the machine behind a tractor. This
prevents hydraulic functions not working at all or working incorrectly.
● Check the direction of rotation and rpm chosen for the power take-off shaft before switching on the
power take-off shaft. Change them if they do not match the required direction of rotation and rpm
(see stickers)!
● Always switch off the power take-off shaft when it is not in use.
● Machines driven by means of a clutch shaft as well as the actual clutch shaft shall only be cleaned,
lubricated or adjusted after the power take-off shaft has been switched off, the motor/engine has
been switched off, and the ignition key has been removed!
● The driver must always be in the driver seat while driving and operating the machine!
● Observe the statutory regulations on transport using public roads. Also pay attention to the lights
required and front, rear and side reflectors!
● Always check that the machine complies with the permissible transport dimensions.
● Switch off the power take-off shaft whenever it is not necessary, as otherwise the oil's viscosity might
worsen unnecessarily.
Safety instructions
31 31