Maintenance; Safety Precautions; Routine; Periodic - Lincoln Electric MAXsa 19 Operator's Manual

D-1

SAFETy PRECAUTIONS

WARNING
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
such as output terminals or internal
wiring.
• When inching, electrode and drive
mechanism are "hot" to work and
ground and could remain energized
several seconds after the inch button
is released.
• Turn OFF input power at welding power source
before installation or changing drive roll and/or guide
tubes.
• Welding power source must be connected to system
ground per the National Electrical Code or any
applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
See additional warning information
throughout this operator's manual and
the Engine manual as well.

MAINTENANCE

ROUTINE MAINTENANCE
• Check weld cables and control cables for cuts.
PERIODIC MAINTENANCE
• N/A

CALIBRATION SPECIFICATION

All calibration is factory set on the MAXsa™ 19
Controller.
MAXsa™ 19 CONTROLLER
D-1