Table of Contents
Advertisement
15 June 2016
Mounting Option 1 - Mounting Bracket using straps
9. Find a suitable place to mount the bracket to the inside of the frame; closest to
the fuel tank. Avoid mounting where the bracket could rub on fuel lines, break
lines and cables. Install straps around frame and bracket and torque to 80-90
in/lbs.
NOTE: The Nylock nut must be on the opposite side of the frame from the bracket.
10. Insert the three rubber isolators
into the support bracket.
some water to aid in lubricating
the isolators as they slide into the
bracket.
Place the large washers on the
inside of the bracket against the
rubber isolator.
Tighten the supplied M8 bolts
through each vibration isolator of
the support bracket and into
mounting
bracket
Repeat this step for the other 2
bolts.
Torque the three bolts to
10-14ft-lbs.
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295
#1050305D 2003-2004½ Dodge Cummins FlowMAX Lift Pump Kit (I-00169)
Use
(PEM)
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bd-power.com
Straps & Frame
Not shown
nut.
BD Engine Brake Inc.
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
- 5 -
Inside of frame
Align strap
close to tabs
Note orientation
of bracket
Mounting bracket
Isolator
Support Bracket
Washer
Bolts
Advertisement
Table of Contents
