Telepen Message Length; Upc A; Upc-A Check Digit; Upc-A Numbe Sys Em - Baracoda BCM 2604 Programming Manual

Baracoda barcode reader

Hide thumbs Also See for BCM 2604:

Table of Contents

Original Telepen Output

3.13.2 Telepen Message Length

Scan the bar codes below to change the message length. Refer to Message Length Description

(chapt 3.2) for additional information. Minimum and Maximum lengths = 1-60. Minimum Default = 1,

Maximum Default = 60.

Minimum Message Length

Maximum Message Length

Default All UPC-A Settings

UPC A

* On

This selection allows you to specify whether the check digit should be transmitted at the end of the

scanned data or not. Default = On.

* On

Off

3.14.2 UPC-A Number System

The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned

data, but the unit can be programmed so it will not transmit it. Default = On.

Table of Contents