KUHN PRIMOR Instruction Manual page 2

The KUHN machine that you have just purchased has undergone a full range of inspections throughout
the manufacturing process. If you should encounter a fault in spite of all the care given to the manufac-
ture of your machine, please contact your dealer who will solve the problem with the assistance of our
after-sales service.
To enable us to satisfy your requirements, please provide the information below when you call us. It
will only take you a few minutes to fill in this page when your machine is delivered but it will save you
a lot of time in the event of a problem.
1- GENERAL DATA
Note the machine references here.
Type of machine
2 - OPTIONAL EQUIPMENT
Tick the boxes corresponding to the options fitted to your machine.
Electric control
Rectangular bales kit
Sealed floor
Manufacturer's address: KUHN-AUDUREAU S.A., B.P. 19, F-85260 LA COPECHAGNIERE
IMPORTANT INFORMATION
PRIMOR
Sequence number in the series
KUHN
Wide angle PTO shaft
Chute type of standard Primor on Primor PH
Category 2/3 linkage bar
2
Date commissioned