Parameter Setup: Alarm Limits - Fisher Scientific accumet XL150 accumet XL200 accumet XL250 accumet XL500 accumet XL600 Reference Manual

13.

PARAMETER SETUP: ALARM LIMITS

The High and Low Alarm Limits are available from any parameter Setup.
Select an Alarm Limit to enable a visual and audible alarm to alert you whenever a High or Low value is
exceeded. When a measurement exceeds the Alarm limit, a corresponding
ALARM" will blink on the display while simultaneously producing a loud, intermittent beep . The alarm
will continue until the conditions are no longer met, and will only be active during measurement mode.
To Set An Alarm Limit:
1. Select ON to enable the Alarm Limits, or OFF to disable the
Alarm Limits.
2. Select the Low window to enter or modify the Low limit
value using the keypad.
3. Select the High window to enter or modify the High limit value using the keypad.
Tip: If you want to use High or Low Alarm only and not both, choose the minimum (Low) or maximum
(High) value. For example, if you want the alarm to notify you when the pH reading goes above 12, but
don't want any other alarm to be active, turn Alarm Limits ON and enter -2.00 as the Low value, and 12.00
as the High value.
19
"HI ALARM" or "LOW