Operating Instructions; How To Install A Grease Cartridge; How To Fill The Grease Gun From A Bulk Lubricant Container; How To Fill A Grease Gun With A Filler Pump - Lincoln 1132 User Manual

Operating instructions

1 Place a grease cartridge into the container
tube. See "How to install a grease car-
tridge" below.
2 Wipe all the fittings clean before
lubricating.
3 Push the coupler onto the grease fitting at
a slight angle and then center the coupler
onto the grease fitting.
4 Squeeze the pistol grip pump handle to
dispense the grease taking care not to
damage seals by excessive pressure or lu-
bricant volume
5 When finished lubricating, turn the cou-
pler at a slight angle to release the coupler
jaws grip
How to install a grease
cartridge
1 Unthread the container tube from pump
head 1 full turn.
2 Pull back the T-handle until the follower
rod is fully extended, approximately 8
inches; pull it sideways to latch the rod
groove into the keyhole slot in the con-
tainer cap.
3 Remove the pump head from container
tube.
4 Remove the plastic cap from the end of
the grease cartridge and insert the open
end into the container tube.
5 Remove the pull tab from the grease
cartridge.
6 Loosely assemble the pump head to the
container tube.
7 Disengage the follower rod from the
container cap.
8 Engage the follower rod with the follow-
er by rotating the T-handle and tap
lightly to ensure the follower has entered
cartridge chamber.
9 Squeeze pump handle while tightening
the container tube into the pump head.
10 Disengage the follower rod from the fol-
lower by rotating the T-handle and push
the follower rod into the container.
Lubricant cartridge
Large
Container
cap
How to fill the grease
gun from a bulk
lubricant container
1 Remove the pump head from container
tube.
2 Pack grease into the cavity of the pump
head.
3 Insert the open end of the container tube
into grease.
4 Slowly pull the follower handle back while
pushing the container tube deeper into
the lubricant to prevent air pockets from
forming in the container tube.
5 When the follower rod is fully extended
pull it sideways to latch the rod groove
into the keyhole slot in the container cap.
6 Loosely assemble the pump head to the
filled container tube.
7 Release the follower rod from the con-
tainer cap and disengage the follower rod
from the follower by rotating the follower
handle.
8 Slowly squeeze pump handle while tight-
ening the container tube into the pump
head.
Small
cap
How to fill a grease
gun with a filler pump
1 Engage the follower rod with the follower
by rotating the follower handle.
2 Insert the grease gun filler nipple (notin-
cluded) into the filler pump socket and ex-
tend the grease gun handle away from the
container tube.
3 Operate the filler pump to fill the grease
gun container. When the follower rod is
fully extended to approximately 8 in. (203
mm) the container is filled
4 Disengage the follower rod from the fol-
lower by rotating the follower handle then
push the follower rod into the container.
performed correctly, grease gun will lose
prime and will continue to lose prime
until cleaned properly.
* Indicates change
4
Filler
nipple
!
Notice*
If inspection and cleaning are not