Curtis 1212S Manual page 14

PARAMETER
Accel Max Speed
Accel Min Speed
Decel High Speed
Decel Low Speed
Rev Accel Max Speed
Rev Accel Min Speed
Rev Decel High Speed
Rev Decel Low Speed
Key Off Decel
E Stop Decel
Curtis 1212S Manual,
Rev. B
DRIVE MENU
ALLOWABLE
RANGE
0.2 – 8.0 s Sets the rate (in seconds) at which the speed command increases when
full throttle is applied and the vehicle is traveling forward. Larger values
represent slower response.
Note: Allowable range is restricted by the Accel Min Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) at which the speed command increases when
minimal throttle is applied and the vehicle is traveling forward. Larger
values represent slower response
Note: Allowable range is restricted by the Accel Max Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) that is used to slow down the vehicle when it
is traveling forward at high speed and throttle is reduced. Larger values
represent slower response.
Note: Allowable range is restricted by the Decel Low Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) that is used to slow down the vehicle when it
is traveling forward at low speed and throttle is reduced. Larger values
represent slower response.
Note: Allowable range is restricted by the Decel High Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) at which the speed command increases when
full throttle is applied and the vehicle is traveling in reverse. Larger values
represent slower response.
Note: Allowable range is restricted by Rev Accel Min Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) at which the speed command increases when
minimal throttle is applied and the vehicle is traveling in reverse. Larger
values represent slower response.
Note: Allowable range is restricted by Rev Accel Max Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) that is used to slow down the vehicle when it is
traveling in reverse at high speed and throttle is reduced. Larger values
represent slower response.
Note: Allowable range is restricted by Rev Decel Low Speed setting.
0.2 – 8.0 s Sets the rate (in seconds) that is used to slow down the vehicle when it
is traveling in reverse at low speed and throttle is reduced. Larger values
represent slower response.
Note: Allowable range is restricted by Rev Decel High Speed setting.
0.2 – 4.0 s Sets the rate (in seconds) that is used to slow down the vehicle at key-off
or in the event of a major fault.
0.2 – 4.0 s Sets the rate (in seconds) that is used to slow down the vehicle during
emergency reverse, i.e., when a throttle command >80% in the reverse
direction is given while the vehicle is moving forward. This gives the
operator a way to stop more quickly when unexpected conditions arise.
3 — PROGRAMMABLE PARAMETERS:
DESCRIPTION
Drive Parameters
11