Manual Updates; Additional Material Needed But Not Supplied - DX Engineering DXE-PS-2B-P Instructions Manual

This unit is RoHS (Reduction of Hazardous Substances) compliant. The components,
including the solder used are all lead free. If you decide to do any modifications or internal
repairs, you should use only lead free solder and lead free soldering tools. Lead free solder
melts approximately 100 degrees (F) higher than the old leaded solder, so you may need to
upgrade your current soldering system.

Manual Updates

Every effort is made to supply the latest manual revision with each product. Occasionally a manual
will be updated between the time your DX Engineering product is shipped and when you receive it.
Please check the DX Engineering web site (www.dxengineering.com) for the latest revision manual.

Additional Material Needed but not Supplied:

 UMI-81343 - Anti-Seize compound - used on the threads of Stainless Steel Hardware to
prevent galling and aid in proper tightening torque.
 Two electrically equal length 50Ω coaxial cables to run from the DXE-PS-2B to each of the
identical Yagi antennas.
 4-Wire Control Cable - COM-CW4 Control Cable is ideal.
 LCT-37534 Dielectric Grease
- 3 -