Advertisement
-Digimax210SE(48~71) 00.10.24 8:34 AM D‰¿Ã¡ˆ68
NOTE IN USING
¢ Ú Maintenance
°§To clear the Lens or LCD Status panel, a soft brush should be used. If this
does not work lens-cleaning paper with lens cleaning fluid can be used.
°§Clean the camera with a soft cloth or a mild detergent. It may cause the
deterioration, deformation or falling off the paint.
°§The LCD moniter can be damaged very easily, please ensure that it does
not come into contact with any sharp impact.
¢ Ú Do not attempt to disassemble or modify the device by yourself.
Warning indicator
°§The warning indicator displayed on the shot information indication is as follows.
warning
warning contents
indicator
¶UNo memorycard
¶UThe card cannot be read.
¶UThe capacity for shot in
memorycard is lacking.
¶UThe camera indicates abnormal
operation.
6 8
treatment
¶UInsert the memorycard.
¶UInsert the memorycard again.
¶UReplace the card with the
new one or use it after you
erase the locked image.
¶UPlease turn the power off and
turn it on again.If it happens
again, please ask for the repair
service to the near Samsung
service center.
BEFORE CONTACTING SERVICE CENTER
Before contacting service center (please check the following)
Symptom
Cause
¶UBatteries need replacing.
The power is
¶UAC Power Adapter
not turned on
is not connected.
¶UBatteries need replacing
¶UCamera has shut off automatically ¶UPower on
If the power
¶UThe card is taken off before the
will not turn on.
image is saved in the memorycard.
¶U
The adapter jack is off because it loosens.
¶UExternal temperature is too cold.
Battery power
is drained
¶UThe camera has old and
quickly.
new batteries
¶UCF Card is not inserted
¶U
The memory card has not been inifialised.
Camera does not
¶UMemory card are almost drained.
take pictures
¶UThe power has not been switched on. ¶UPower on.
when pressing
the Shutter
¶UThe batteries are weak.
b u t t o n .
¶UThe camera is not set to
shooting mode.
The focus cannot
¶UYou select the wrong shot mode.
be adjusted.
¶UThe camera is flash off
The flash mode
does not work.
¶UThe wrong date/time is displayed
The wrong date
or saved as the basic number.
/time is displayed.
Steps
¶UReplace batteries with new ones
¶UConnect AC Power Adapter.
¶UReplace batteries with new ones
¶UDo not remove the memorycard
while you save the image.
¶UPlug in the adapter jack again.
¶UKeep batteries at the correct
t e m p e r a t u r e .
¶UReplace all batteries and
insert new ones
¶UInsert CF Card
¶UI n i t i a l i s e
¶U
Insert new CF Card from manufacturer
¶UReplace batteries with new ones
¶UShooting mode
¶USelect the macro mode in case it is
within 80 cm and select the
general mode in case it is over 80cm.
¶UThe flash off mode is canceled.
¶USelect the appropriate number in
MENU mode.[Refer to the selecting
DATE/TIME on the page 21.]
6 9
Advertisement
