Advertisement
-Digimax210SE(72~) 00.10.24 8:35 AM D‰¿Ã¡ˆ112
CONNECT THE CAMERA
Connecting Macintosh USB connecting point
°·Digimax 210SE USB TWAIN Driver for MAC, was designed for USB port only.
Therefore, it requires built-in USB port with built-in Mac hard disk or keyboard.
1
Connect the USB cable to the USB port on the
c o m p u t e r .
2
Connect the other end of the USB cable to the
USB port of the camera.
3
Set the mode dial.
4
Switch the camera on.
Connecting Macintosh communications connecting jack for Macintosh
°·Digimax 210SE Serial TWAIN Driver for MAC was designed for Modem port only.
(not for printer port)
1
After connecting the adapter for Macintosh to
the RS-232C cable, connect the adapter for
Macintosh with the to the modem port.
2
Connect the one end of the connected cable
terminal to the DIGITAL connecting terminal of the
c a m e r a .
3
Set the mode dial.
4
Switch the camera on.
1 1 2
H OW TO USE DIRECT DOW N L OA D
P RO G R A M
How to run the Direct Download for the Macintosh users
1
Plug in the exclusive cable (USB cable or Serial Cable) to the USB port of the
Macintosh or to the terminal of the camera. Refer to the page 112 about connecting
the cable.
2
Please (
) the mode dial and turn the power on.
3
Open the folder "DirectDown_USB" or "DirectDown_Serial" and run the
DirectDown program in the folder.
<When you use a USB connecting terminal>
The following frame is displayed when the program is normally run.
<When you use a communication
connecting terminal>
1 1 3
Advertisement
