Yaesu VX-150 Operating Manual page 10

Operation
When you wish to transmit, wait until the channel is clear (BUSY/TX lamp off), and squeeze
the PTT switch. During transmission the BUSY/TX lamp glows red, and relative transmit-
ter power output is indicated graphically along the bottom of the display. Release the PTT
switch to receive.
If using a version B (in Europe), press the T-CALL switch (above the PTT switch) to
transmit a 1750 Hz tone to access repeaters that require it.
Tuning steps are factory preset to 20 kHz. To change a frequency step, follow the proce-
dure below:
•
Press the [ F/W ] key, then immediately press the [ 0 ( SET ) ] key to enter the Set mode.
‚
Rotate the DIAL to select Menu Item #7 ("STEP
ƒ
Press the [ F/W ] key to enable modification of the current setting.
„
Now rotate the DIAL knob to select 5, 10, 12.5, 15, 20, 25 or 50 kHz steps.
...
Press the PTT key to save the new setting and exit to normal operation.
10
T
RANSMITTING
C
HANGING THE
C S
HANNEL TEPS
STEP STEP
STEP STEP").
VX-150 O M
PERATING ANUAL