DREAMS Crystal Bed Assembly Instructions

Download this manual

Crystal Bed

Assembly Instructions

Before you

Start, here are

some helpful

advices.

Component parts and fittings contained in the box

1. We suggest you spend a short time reading through this leaflet and

then follow the simple step by step instructions.

2. If you follow the instructions carefully the end result should be worth

the effort.

3. Do not discard any of the packaging until you have checked that

you

have all the parts and the pack of fittings.

4. Assemble this product on a carpet.

5. To ensure an easier assembly, we strongly advise that all fittings

are only finger tightened during initial assembly. Only upon

completion of the. Assembly should all fixing points be fully

tightened.

6. We recommend a periodic check on all fixing points to make sure

they remain fully tightened.

7. Keep glue and fi

In the unlikely event that this product has missing or damaged parts,

please call 08442 920000 to obtain spares

Need help?

Do you have a question about the Crystal Bed and is the answer not in the manual?

Page 1 Crystal Bed Assembly Instructions Before you 1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. Start, here are 2. If you follow the instructions carefully the end result should be worth some helpful the effort.
Page 2 PARTS Fittings...
Page 3 1) Use bolt (A), washer (D) and plastic washer (E) to fix the side rail (3) onto headboard (1) and footboard (2) by using Allen Key (F). Attach the crystal finials (4) onto headboard (1) and footboard (2) by turning it clock-wise.
Page 4 Both slats on "step 2" and "step 3" can be assembled to the bedstead. you can make a choice between the two slats. OPTION"A": DREAMS FIXED WOOD SLATS 1)Carefully locate the slats onto the unit. 2)Use bolt (B) and JCN nut (C) to fix the...
Page 5 OPTION"B": DREAMS SPRUNG SLATS 1) Use the bolt to fix support leg onto the slat frame. Please note that these bolts are to be found inside the slat frame box. 2) Carefully locate the slats onto the unit. Use bolt (B) and JCN nut (C) to fix the...