Download Print this page

DREAMS CAMBRIDGE BED Assembly Instructions Manual

Advertisement

Quick Links

Assembly Instructions
Minimum No.of people
recommended to assemble
this product :
Approx assembly time :
Before you
Start, here
is some
helpful advice
In the unlikely event that this product has missing or damaged parts,
please call
CAMBRIDGE BED
2
3/4
hour
1. We suggest you spend a short time reading through this leaflet and
then follow the simple step by step instructions.
2. If you follow the instructions carefully the end result shoud be worth
the effort.
3. Do not discard any of the packaging until you have checked that yo u
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are
only finger tightened during initial assembly.
6. We recommend a periodic check on all fixing points to make sure they
remain fully tightened.
7. Keep glue and fittings out of chidren's reach.
0844 292 0000 to obtain spares

Advertisement

loading
Need help?

Need help?

Do you have a question about the CAMBRIDGE BED and is the answer not in the manual?

Questions and answers

Summary of Contents for DREAMS CAMBRIDGE BED

  • Page 1 CAMBRIDGE BED Assembly Instructions Minimum No.of people recommended to assemble this product : Approx assembly time : hour 1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2. If you follow the instructions carefully the end result shoud be worth Before you the effort.
  • Page 2 Component parts and fittings contained in the box PARTS 2 ( 1piece ) 1 ( 1piece ) 4 ( 1piece ) 3 ( 1piece ) FITTINGS x 04pcs x 04pcs (M6x20) x 06pcs x 02pcs x 01pc x 06pcs (4x35) x 08pcs (M6x45) x 04pcs...
  • Page 3 ASSEMBLY Connect Side Rails 2 Step 1 and 4 to Footboard Screws F by 3 with using Allen key E. Note : Do not fully tighten at this point Repeat the process outlined in step 1 with Step 2 the Headboard 1. Once the side Rails 2 and 4 have been connected to both the...
  • Page 4 Identify the slat system you have purchased... Sprung slat system Turn to steps ,4,5 Standard wooden slat system Turn to step 6...
  • Page 5 Sprung Slat System Assembly Step 3 Step 4 Adjust leg height to suit bed frame...
  • Page 6 Finally, tighten by JCN Nut H onto the Bolt G from the underside of the Side Rail, as shown FIXED WOOD SLAT ASSEMBLY DREAMS FIXED WOOD Step 6 SLAT SYSTEM Position the Solid Wood Slat so that the holes in...