Maintenance
On threads of Blade Bolts. See Check Mower
Blades section.
Dielectric Grease
Dielectric grease is used on all blade type electrical
connections to prevent corrosion and loss of contact.
Dielectric grease should not be applied to sealed
connectors.
Adjustments
Note: Disengage PTO, shut off engine, wait for
all moving parts to stop, engage parking brake, and
remove key before servicing, cleaning, or making any
adjustments to the unit.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to
fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands or
equivalent support.
Deck Leveling–
60 and 72 Inch Models
1.
Position the machine on a flat surface.
2.
Shut off the engine, wait for all moving parts to
stop, remove the key, and engage the parking
brake.
3.
Check the tire pressure in drive tires and
pneumatic front caster tires (if equipped). Proper
inflation pressure for tires is 18 psi (124 kPa).
Adjust if necessary.
4.
Using the deck-lift switch, move the deck height
out of the transport position (or 5 1/2 inches (140
mm) cutting height).
1. Height of cut bracket
56
Figure 42
2. Height of cut pin
g227689