13
model no. 052-0060-2 | contact us 1-800-689-9928
Measuring AC Voltage
1.
2.
3.
4.
Measuring DC Current
1.
NOTE:
To avoid electric shock to you or damage to the meter, do not
apply a voltage higher than 300 V between terminals.
Connect the black test lead to the "COM" terminal and the red
test lead to the "VΩmA" terminal.
Set the range switch to desired
of the voltage to be measured is not known beforehand, set the
range switch to the highest range first and then reduce it until
satisfactory resolution is obtained.
Connect the test leads across the source or circuit to be tested.
Read the reading on the display.
NOTE:
To avoid electric shock to you or damage to the meter, do not
apply a voltage higher than 300 V between terminals.
Connect the black test lead to the "COM" terminal. Connect the
red test lead to the "VΩmA" terminal if the current to be
measured is less than 200 mA. If the current is between 200 mA
and 10 A, connect the red test lead to the "10 A" terminal
instead.
range position. If the magnitude