Table of Contents
Advertisement
5. Data Output
[Output
Example]
[Output
Example]
<Command Explanation>
Command
P
*
N
*
M
*
T
* When page number is entered incorrectly, the error message E will be returned.
As for E1 and E3, refer to 5.2.3 To Transfer Raw Data (measurement data per second).
1.800.561.8187
Output Format of Measurement Condition ----- M Command
(2)
(1)
(3)
# # ; # # # ; # # ; # # # ; # # # ; # # # # # CRLF
(1) Measurement Mode (VI: Air Velocity & Air Temperature)
Calculation Mode
(2)
(AVE: Average Measurement INT: Interval Measurement FLW: Flow Measurement)
(3) S-TIME (S) (Sampling Time)
(4) DATA (N) (Number of Data to be collected)
(5) POINTS (No. of samplings (partitions))
(6) Interval Measurement: INT(measurement interval)
Flow Measurement: AREA (m2) (Duct's cross section area)
(2)
(4)
(1)
(3)
VT ; FLW ; 60 ; 100 ; 10 ; 1. 456CRLF
Output Format of Measurement Data ----- T Command
# # # # # ; # # # # # ; # # # # # CRLF ：19 Characters
air velocity
air temp
23.6;
126;
Function
To check the number of
memory pages
To check the number of
memory data
To check measurement
condition
To output measurement
data
www.
(6)
(4)
(5)
(6)
(5)
dummy
： (Unit: m/s, ˚C, **)
：air velocity, air temp, dummy
*** CRLF
After the command is received, AP will be returned.
Then, the number of pages stored will be output.
After the command is received, AN will be returned.
Then, the number of data in the specified page (*) will be output.
After the command is received, AM will be returned.
Then, the measurement condition in the specified page will be output.
After the command is received, AT will be returned.
Then, the measurement data in the specified page will be ouput.
.com
: 25 Characters
* AVG Mode:
dummy output
Explanation
information@itm.com
35
Advertisement
Table of Contents
