Table of Contents
Advertisement
4.2 Basic Setups
4.2.1 Set up the Time and Date
Time: Present power meter time; the time format includes the hour, minute, and second.
Date: Present power meter date; the date format includes the last two digits of the year, month, date and
day.
Set up Steps
1.
Press MENU to display the setting menu.
2.
Select 0 and press ENTER to enter the Setup menu.
3.
Select 1 and press ENTER to enter the Date menu.
4.
Select Date or Time and then press ENTER to set the date or time.
5.
After you select the option, use UP and DOWN to set the time and date.
6.
Press ENTER to confirm the number and move to the next number.
7.
Repeat steps 5–6 until you complete the date and time settings. Press ENTER to save the setting or
press MENU to cancel without saving the changes.
8.
Press MENU to go back to the setting menu.
4.2.2 Meter Information
Meter related information:
Model: DPM-C530
FW Version: Firmware version; 1.xxxx
FW Date: Firmware release date; XXXXYYZZ (XXXX: year, YY: month, ZZ: day)
Meter Const: Meter constant, amount of kWh used
Operation Time: Total operation time by days and by clock.
Set up Steps
1.
Press MENU to display the setting menu.
2.
Select 0 and press ENTER to enter the Setup menu.
3.
Select 2 and press ENTER to enter the Meter Information page.
4.
Press MENU to go back to the setting menu.
4.2.3 Set up the Communication
Address (ID): Device ID; the address range is 1–254 (default: 1). 255 is the broadcast ID.
Protocol: Transmission modes; options are RTU (default) and ASCII.
Baud Rate (BR): Transmission speed; options are 9600 kbps (default).
Data Bit: Packed data length; options are 7- and 8-bit (default). 8-bit is the only option for RTU mode.
Parity setting (PA): Odd and even checking bit for communication; options are None (default), Even and
Odd.
Stop Bit: The transmission complete signal; options are 1- (default) and 2-bits.
C h a p t e r 4 O p e r a t i o n
4 - 3
4_
Advertisement
Table of Contents
