Coxo C-SMART-1 Pro User Manual page 6

8_3 Operation·........................·······........................···14
8.3.1 M2 Apex locator only(without motor.)·..........................14
8.3.2 M2 Motor only (without apex locator)··························
8.3.3 Motor and Apex locator (Dual mode)······················
M3
8.4 Functional check of the apex locator································31
8.5 Calibration....................·········........................······ 33
8.6 Factory Default Parameters- ......·········........................·36
9 Maintenance, Cleaning and Disinfection············
9.1 General . ..................········.......................········.....37
9.2 Cleaning, Disinfection and Sterilization·····························38
(according to DIN EN ISO 17664)
9.2.1 Pre-treatment··················································· 38
9.2.2 ManualCleaning and Disinfection······························38
9.2.3 Inspection/Maintenance .......................................38
9.2.4 Packing·......·········........................·········........
9.2.5 Sterilization·..................·········......................···
9.2.6 Storage ......................................................... 40
9.2.7 Material Resistance············································40
········· ..· .. ··· ...... ·· ...... ·· ..· ..
10 Troubleshooting
11 Guarantee . ...........................................
12 Technical services ..................................
0 Troubleshooting
If the device is not working
·22
calling our service center.
·28
Problem
The power is
not turned on.
·37
The motor
handpiece
does not rotate
39
Apex
39
measurement
is not correct.
41
File blocks in
the root canal.
42
· 42
C-SMART-1 Pro Uoer Manual
properly, please check the following table before
Cause
Change the
The battery is bad.
The motor handpiece or the
Contact your distributor.
motor handpiece cord Is
damaged.
Clean or replace the
The contra-angle is clogged.
contra-angle.
There is a short circuit inside
the motor handpiece or the
Contact your distributor.
motor handpiece cord.
Check the connection
The file has no contact with
between the file and the file
the handpiece or file holder
holder,
correctly.
Motor or test wire is not
Check the connection.
properly connected.
Change the rotational
Wrong file setting.
direction. Start the motor
Too much pressure on the
and pull out the file carefully.
instrument.
File not frequently cleaned.
Clean the file frequently.
Solution
battery.
clean it if necessary.
Ill