Video Settings - Pioneer SPH-DA130DAB Operation Manual

3
Disconnect the iPhone or smartphone device.
4
Turn on the ignition switch (ACC ON).
If the vehicle's air conditioner or heater is turned on, turn it off.
5
Switch the AV source to [Source OFF] (page 16).
6
Press (touch) .
7
Touch then .
8
Touch [A-EQ&TA Measurement].
9
Connect the microphone for acoustical measurement (sold separately) with this
product.
Plug the microphone into the AUX input jack on the back panel of this product.
NOTE
Use an extension cable (sold separately) if the cord of the microphone (sold separately) is not long
enough.
10
Touch [Front Left] or [Front Right] to select the current listening position.
11
Touch [Start].
A 10-second countdown starts.
NOTE
The Bluetooth connection is disconnected before the process starts.
12
Exit the vehicle and keep the doors closed until the countdown finishes.
When the countdown finishes, a measurement tone (noise) is emitted from the
speakers and Auto EQ measurement begins.
13
Wait until the measurement is completed.
When Auto EQ is completed, a message is displayed.
NOTE
The measurement time varies depending on the type of vehicle.
TIP
To stop the measurement, touch [Stop].
14
Store the microphone carefully in the glove box or another safe place.
If the microphone is subjected to direct sunlight for an extended period, high
temperatures may cause distortion, colour change, or malfunction.
Adjusting the cutoff frequency value
You can adjust the cutoff frequency value of each speaker.
The following speakers can be adjusted:
[Standard Mode]: Front, Rear, Subwoofer.
[Network Mode]: High, Mid, Subwoofer.
NOTE
[Subwoofer Settings] is available only when [Subwoofer] is [On].
1
Press (touch) .
2
Touch then .
3
Touch [Crossover] or [Subwoofer Settings].
4
Touch or to switch the speaker.
5
Drag the graph line to set the cutoff position.
6
Drag the lowest point of the graph to set the cutoff slope.
The following items can also be set.
Switches the subwoofer phase between normal and reverse position.
Switches the LPF/HPF setting to [On] or [Off]. When it is turned off, the high-pass
LPF/HPF
filter or low-pass filter of each speaker can also be turned on by touching the
graph lines.

Video settings

The menu items vary according to the source.
[Time Per Photo Slide]
Menu Item Description
[Time Per Photo Slide] Select the interval of image file slideshows on this product.
[5sec] [10sec] [15sec]
[Manual]
[Video Signal Setting]
Menu Item Description
[AV] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to an AV equipment.
M] [PAL-N] [SECAM]
[AUX] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to an AUX equipment.
M] [PAL-N] [SECAM]
[Camera] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to a rear view camera.
M] [PAL-N] [SECAM]
41
En