Two Brothers Racing TARMAC Installation Instructions

Honda cbr500r

Download this manual

Honda

CBR500R

V.A.L.E.™ Slip-on Exhaust System with M-2 Exhaust Canister

Part # 005-3950405-T

IMPORTANT - PLEASE READ CAREFULLY

Two Brothers Racing products are intended for closed course competition

purposes only.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions

first before starting installation. Make sure the motorcycle and exhaust system

are completely cool before starting the installation. Also, make sure the bike is

secure on a centerstand or ideally a service lift during installation. Be sure to save

all stock components for possible use later.

Make sure the bike is completely cool before starting the

installation. Make sure the bike is secure on a centerstand or

ideally a service lift.

Loosen OEM muffler clamp.

Remove OEM muffler mounting hardware.

Remove OEM muffler assembly. OEM gasket will not be used

with TBR exhaust.

Apply a thin layer of anti-seize to TBR slip tube outlet and

connect to Tarmac muffler using supplied hook springs.

Loosely install barrel clamp onto slip tube inlet.

Install TBR slip-on assembly onto stock header and attach

muffler bracket to passenger peg mount using supplied bolt,

washer, and nut. Tighten to snug.

Installation Instructions

Tighten barrel clamp at header connection.

Before you run the bike, clean off all fingerprints and dirt, as

any oily residue will etch the metal and become somewhat

permanent when the system gets hot. Run the bike and

enjoy. It is normal for some white smoke to appear the first

time you start the bike. This is packing/manufacturing oil from

inside the pipe burning off. Check for gaps or leaks. If you find

a leak, a little high temperature silicon sealant should fix it.

After 50 to 100 miles, recheck all fasteners for tightness.

Page 1 Tarmac muffler using supplied hook springs. Loosely install barrel clamp onto slip tube inlet. IMPORTANT - PLEASE READ CAREFULLY Two Brothers Racing products are intended for closed course competition purposes only. We recommend that this performance part be installed by a qualified motorcycle Install TBR slip-on assembly onto stock header and attach technician.
Page 2 Warranty Information Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use...