Control Data Corporation 3300 Reference Manual page 184

60229400
During execution of the first GENERATE statement, report groups are produced
in the following order:
REPORT HEADING report group
PAGE HEADING report group
all CONTROL HEADING report groups in the order FINAL, major to minor
DETAIL report group,
if
specified in the GENERATE statement
If a control break is recognized when any GENERATE statement after the first
is executed, all specified control footing report groups are produced from the
minor report group up to and including the report group specified for the identi-
fier which caused the control break. Then, all specified control heading report
groups from the report group specified for the identifier that caused the control
break down to the minor report group, are produced in that order. The detail
report group specified in the generate statement is then produced.
Data is moved to the data item in the report group description entry of the
Report Section, and it is edited under control of the Report Writer aCfJording
to the same rules for movement and editing as described for MOVE.
5-27