Warranty, Defects, Wear; Wear; Technical Data - Stromer ST3 User Manual

WARRANTY, DEFECTS, WEAR

You were given the warranty and limitation of li-
ability separately at the time of purchase of your
S-pedelec. You can also consult them anytime at
www.stromerbike.com/support.

Wear

Take note that the components of the S-pedelec
are subject to higher wear than the components
of a bicycle without an additional drive. This is
due to the greater weight of the vehicle and the
higher average speed that is achieved through the
propulsion.
This higher wear is not a defect and is not subject
to warranty.
Typical components affected are:
• Tires • Drive components
• Brake pads • Spokes
The battery is subject to aging and therefore a
wearing part. Please take note that age and dura-
tion of use affect the battery, e.g. result in a clear-
ly reduced driving range. This must be considered
when planning trips. Exchange our battery in due
time for a new one. Replacement batteries are
available from your Stromer dealer.

TECHNICAL DATA

Permitted total weight of Stromer S-Pedelec: 150 kg
Vehicle including battery + driver + luggage + trailer
Stromer ST5 and ST3 Weight: 29.2 kg
MOTOR
MOTOR SUPPORT
POWER
POWER USA
TORQUE
RANGE
* Depending on the location of use, a driving permit and insurance/number plate may be required.
The A-weighted emission sound pressure levels at the rider's ears is below 70 dB(A).
CHARGERS
INPUT
OUTPUT
OPERATING TEMPERATURE RANGE [°C]
ST5
SYNO Drive Sport*
up to 45 km/h
850 W
650 W
48 Nm
up to 180 km
CR245
100-240VAC ~
50-60 Hz
3A
54.6VDC / 4.5A
11.2VDC / 1A
0...40°C
ST3
SYNO Drive II*
up to 45 km/h
820 W
600 W
44 Nm
up to 180 km