Installing The Sr-1000 Into The Projector; Projector Network - GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK User & Installation Manual

2.INSTALLING SR-1000 INTO THE PROJECTOR

2.2. Installing the SR-1000 into the projector

Please make sure the projector is powered off before installing the SR-1000 on the projector.
Note: Please check the SR-1000 for any physical damage like loose or burnt component before
installing it into the projector.
Insert the SR-1000 as shown in Figure 7. The SR-1000 should slide into the projector on the rails
provided by the IMB slot, and the SR-1000 faceplate should be flush with the other existing
faceplates once properly inserted.

2.3. Projector Network

Connect the provided Cat 5e LAN cable from the SR-1000 Gigabit 2 port to cinema network.
Please see Section 5 for IP network instructions after the SR-1000 is installed.
Installation Manual for SR-1000 Standalone Integrated Media Block™
Figure 7 Installing the SR-1000 into the projector.
- 11 -
March 15, 2018