Table of Contents
Advertisement
X-TRACTOR
®
8A WELDING FUME EXTRACTOR
INSTALLATION
Install the X-TRACTOR 8A on a solid foundation that is flat and even.
Make sure the operator has easy access to all switches and controls.
Do not expose the unit to temperatures over 104º F (40º C), as this
will reduce the motor power and shorten the life of the unit.
The installer is responsible for following Federal, State and
Local safety codes and regulations.
Before drilling, verify locations of existing gas, water, or
electrical conduits.
ELECTRIC SHOCK can kill.
•
Do not touch electrically live parts such as
internal wiring.
•
Turn the input power off at the fuse box before working
on this equipment.
•
Have a qualified person install and service this
equipment.
FALLING EQUIPMENT can cause injury.
•
Lift only with equipment of adequate lifting
capacity.
•
Be sure machine is stable when lifting.
•
Well trained personnel must execute all lifting
operations.
•
Make sure to use only approved lifting gear.
ONLY QUALIFIED PERSONNEL SHOULD INSTALL,
USE OR SERVICE THIS EQUIPMENT.
SELECT SUITABLE LOCATION
Select a dry, firm, level surface capable of supporting the weight of
the machine.
1. Connect hoses/tubes to the inlet/outlet.
2. Connect compressed air. Adjust pressure regulator at front to
4 bar.
3. Connect signal cable to external start/stop switches. (If
applicable).
4. Apply the correct input power.
Only qualified personnel should perform this function.
WARNING
RECOMMENDED USES
Read and understand this entire section before operating
your X-TRACTOR 8A.
Always operate this equipment with the filters installed
and covers in place as these provide maximum
protection from moving parts and insure proper vacuum
operation and cooling airflow.
The X-TRACTOR 8A is a high vacuum welding fume extractor
designed for the removal and filtration of welding fumes released
from the following welding processes:
• MIG/MAG solid wire (GMAW)
• MIG/MAG flux cored wire (FCAW)
• Stick welding (SMAW)
• TIG (GTAW) welding
Use of the product for extracting and/or filtering fumes
and/or gases that are released from the following
processes is not recommended:
• Welding applications with intensive use of anti-spatter
spray, paste or solution.
• Autogenic or plasma cutting spray/molten metal.
• Arc-air gouging.
• Welding that produces the release of a dense oil mist.
• Paint spraying.
• Extraction of hot gases [more than 104° F (40° C)].
• Extraction of aggressive fumes (such as acids).
• Grinding aluminum and magnesium.
• Flame spraying.
• Extraction of cement, saw dust, wood dust, etc.
• Extracting cigarettes, cigars, tissues and other burning
particles, objects and acids.
• Any dangerous situations where there is a risk of an
explosion or fire.
Note: The X-TRACTOR 8A does not filter any shielding gases. Gases pass
through the filter.
10
INSTALLATION
WARNING
WARNING
Advertisement
Table of Contents
