Canon Super G3 Service Manual page 91

Installation > Installation Procedure > Installing the Speaker
8) Install the cover in the Toner Container Replacement Unit Inner Cover.
CAUTION:
• When installing, be sure to install the Toner Container Replacement Unit Inner Cover
while the 4 Parallel Pins of the Inner Door Link Shaft are tilted at an angle of approx.
45 degrees.
Parallel Pin
45 deg
• When installing, be carefulnot to damage the Toner Insertion Entrance Cover Sensor
and the 4 groundingwires on top of the sernsor.
Toner Insertion Entrance
Cover Sensor and Grounds
Toner Container
Replacement Unit
Inner Cover
Installation > Installation Procedure > Installing the Speaker
F-6-23
Toner Insertion Entrance
Cover Sensor and Grounds
F-6-24
9) IInstall the Upper Front Cover. (2 Hinge Shafts)
10) Close the Front Cover and the Upper Front Cover.
11) Connect the PTT Plug matched the field or area to the Telephone Cable (6 contact
type).
NOTE:
This procedure is for Europe.
Do not connect the Telephone Cord (2 contact type) with the PTT Plug.
12) Connect the end of the PTT Cable or Telephone Cord to the Modular Jack (LINE 1)
on the host machine, and connect the other end to the Modular Jack on the wall.
11
F-6-25
F-6-26
11