Canon Super G3 Service Manual page 33

5
Service Mode Service Mode > Details of Service Mode > #SSSW > Details
● SSSW-SW34
List of Functions
Bit Function
0 Display the waste toner full warning
1 Switch the waste toner full warning
2 User drum replacement menu display
3 not used
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 0
You can select whether a waste toner full warning is to be displayed.
When "1" is selected, a waste toner full warning is displayed.
When "0" is selected, a waste toner full warning is not displayed.
Detailed Discussions of Bit 1
Select whether to display the waste toner full warning as a drum replacement required
message or as E019 displayed on an operator call. Select 1 to display a rum replacement
required message on an operator call. Select 0 to display E019 on an service call.
Detailed Discussions of Bit 2
Select whether to display the user drum replacement menu.
When "1" is selected, the menu is displayed.
When "0" is selected, the menu is not displayed.
5 Service Mode > Details of Service Mode > #SSSW > Details Service Mode
1 0
Yes No
Waste toner container
replacement required E019 displayed on
message displayed on an an service call
operator call
Yes No
- -
- -
- -
- -
- -
● SSSW-SW35
List of Functions
Bit Function
0 e-RDS function ON/OFF
1 Call button function ON/OFF
2 ScanToMeia function enable/disable
3 MediaPrint function enable/disable
4 IC card authentication management function ON/OFFYes
Handling of a scan job at device logout
5
Default: 0
Handling of display of the stop confirmation screen
6 when the stop key is pressed during a scan job,
except remote scan
T-5-23
Switching to display/hide the start button of the
7 counter print (known as billing counter report)
Default: 1
Detailed Discussions of Bit 0
Select whether to set the e-RDS function.
When "1" is selected, the function is set.
When "0" is selected, the function is not set.
Detailed Discussions of Bit 1
Select whether to set the call button function.
When "1" is selected, the function is set.
When "0" is selected, the function is not set.
Detailed Discussions of Bit 2
Select whether to enable or disable the ScanToMeia function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
Detailed Discussions of Bit 3
Select whether to enable the MediaPrint function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
Detailed Discussions of Bit 4
Select whether to set the IC card authentication function.
When "1" is selected, the function is set.
When "0" is selected, the function is not set.
5-12
1 0
Yes No
Yes No
enable disable
enable disable
No
Stop a scan job Not stop a scan job
Not display the stop Display the stop
confirmation screen confirmation
(same specification screen (the display
as that of the specification following
existing models) that of the iR series)
Display the counter Hide the counter print
print button button
T-5-24
5-12