Table of Contents
Advertisement
6. CAMERA RE-ASSEMBLY
Make sure all wires are properly connected, all
holes are sealed against moisture penetration,
and all mounting screws are tight.
Step 6.1 -
Step 6.2 -
Step 6.3 -
Slide the square foam pad over the
camera's lens. Make sure the pad is
as close to the faceplate viewing
window as possible and the
photocell is not covered by the foam
pad. The foam pad is not
symmetrical. Make sure the LEDs
are not covered when installing the
pad.
Re-attach the faceplate with the six
tamper resistant screws. Tighten
carefully but do not over-tighten.
Power-up the camera and check its
operation.
Refer to Figure 6-1 on page 17.
16
Advertisement
Table of Contents
Troubleshooting
