Configuring A Static Route To An Asbr Confederation Peer - Cisco NCS 540 Series Configuration Manual

Configuring a Static Route to an ASBR Confederation Peer

RP/0/RP0/CPU0:router(config-bgp)# mpls activate
RP/0/RP0/CPU0:router(config-bgp-mpls)#
Enters BGP MPLS activate configuration mode.
Step 4 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-bgp-mpls)# interface GigabitEthernet 0/0/0/0
Enables MPLS on the interface.
Step 5
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring a Static Route to an ASBR Confederation Peer
Perform this task to configure a static route to an Inter-AS confederation peer.
Procedure
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters XR Config mode.
Step 2
router static
Example:
RP/0/RP0/CPU0:router(config)# router static
RP/0/RP0/CPU0:router(config-static)#
Enters router static configuration mode.
Step 3
address-family ipv4 unicast
Example:
RP/0/RP0/CPU0:router(config-static)# address-family ipv4 unicast
L3VPN Configuration Guide for Cisco NCS 540 Series Routers, IOS XR Release 6.3.x
42
MPLS L3VPN Overview