Hardware Installation; Initial Checks; Installation - GE PACSystems RX3i CPE400 Quick Start Manual

Hardware Installation

Initial Checks

Upon receiving your equipment, carefully inspect all shipping containers for damage.
If any part of the system is damaged, notify the carrier immediately. The damaged
shipping container should be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for
damage incurred during shipment. GE will fully cooperate with you, however, should
such action be necessary.
After unpacking the equipment, record all serial numbers. Serial numbers are
required if you should need to contact Customer Care during the warranty period. All
shipping containers and all packing material should be saved should it be necessary
to transport or ship any part of the system.
Verify that all components of the system have been received and that they agree
with your order. If the system received does not agree with your order, contact
Customer Care.

Installation

As shipped, the CPE400 is intended for mounting on a DIN rail. A panel-mount
adaptor is also available. If panel-mounting is required, replace the DIN-rail adaptor
with the panel-mount adaptor using the screws supplied with that adaptor. Both
adaptors attach to the rear of the CPE400 chassis using four Torx M3 screws. Torque
newly-installed screws to 5.3 in-Ibs (0.6 Nm) if installing a new adaptor plate.
For installation to standards, refer to the Installation and Maintenance Requirements
document, GFK-3004.
Note the thermal requirements for mounting the equipment (Figure 3).
Mount on the DIN rail per Figure 4. (1) Incline the unit so that the upper hooks of the
DIN rail adaptor engage with the upper edge of the DIN rail. (2) Press on the lower
part of the unit until you hear a click. The click indicates that the lower hooks of the
DIN rail adaptor have engaged with the lower edge of the DIN rail.
Dismount from the DIN rail per Figure 5. (1) Grasp the unit securely. (2) Press down on
the release bar as indicated. (3) Swivel the unit away from the DIN rail, then remove.
GFK-3002A October 2017 10