Switches; Displays And Indicators (Leds) - GE PACSystems RX3i CPE400 Quick Start Manual

Switches

All user-accessible switches are provided as pushbuttons on the front panel (Figure 1)
as described below.
Pushbutton
DISP
SEL
RUN
STOP
PHY PRES
PWR

Displays and Indicators (LEDs)

OLED Display
The monochrome organic light-emitting diode (OLED) display (Figure 1) is used to
display CPE400 system menus. It interacts with the DISP pushbutton, which jogs the
cursor from one menu item to the next, and with the SEL pushbutton, which activates
the currently indicated menu item for further action.
The OLED display permits the user to:
•
Display Ethernet LAN Settings: IPv4 address.
•
Display the PLC firmware revision.
•
Set/view PLC mode and view sweep time.
•
Set the PLC mode to RUN/STOP with I/O Enabled/Disabled via the display.
Note: the RUN and STOP pushbuttons activate the PLC Mode menu items per
Section 1.1.
•
View whether all, some, or none of the PROFINET I/O devices are connected.
•
Display EFA Settings: IPv4 address, subnet mask, gateway, MAC address,
IPv6 address.
•
Issue Field Agent Commands
Configuration, Perform factory reset.
•
View Field Agent Status: Off, Starting, Connecting, Connected, Connected-ACT.
•
View HSB Redundancy Mode and State (Release 9.30 and later)
•
Command an HSB Redundancy Role Switch (Release 9.30 and later)
GFK-3002A
Function
Permits user to navigate menus in the OLED display.
Permits user to select the menu item on the OLED display.
Activates OLED Menu to select RUN/Enabled or RUN/Disabled
Mode for the embedded PLC.
Activates OLED Menu to select STOP/Enabled or STOP/Disabled
Mode for the embedded PLC.
Not functional.
Hold down for brief period to induce CPU Reset.
Note that this does not turn unit power off, but only holds unit in Reset
:
Enter/Exit Configuration mode, Clear
October 2017 4