Verifying Cem For Cesopsn On T1 Interface - Cisco T1 Configuration Manual

Verifying CEM for CESoPSN on T1 Interface

Verifying CEM for CESoPSN on T1 Interface
Use the following commands to verify the pseudowire configuration for CESoPSN:
• show cem circuit—Displays information about the circuit state, administrative state, the CEM ID of the
• show mpls l2 vc—Displays information about the MPLS VC.
• show mpls l2 vc detail—Displays detailed information about the MPLS VC.
PE1#show mpls l2 vc 10
Local intf
-------------
CE0/4/32
PE1#sh mpls l2 vc 10 det
PE1#sh mpls l2 vc 10 detail
Local interface: CE0/4/32 up, line protocol up, CESoPSN Basic 0 up
Destination address: 2.2.2.2, VC ID: 10, VC status: up
Create time: 00:21:25, last status change time: 00:21:25
Signaling protocol: LDP, peer 2.2.2.2:0 up
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
SSO Descriptor: 2.2.2.2/10, local label: 577
Dataplane:
VC statistics:
Router#show cem circuit int cem 0/4/32
CEM0/4/32, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
48-Port T1/E1 CEM Interface Module Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
6
circuit, and the interface on which it is configured. If cross connect is configured under the circuit, the
command output also includes information about the attachment circuit status.
Local circuit
-------------------------- --------------- ---------- ----------
CESoPSN Basic 0
Output interface: Te0/0/0, imposed label stack {650}
Preferred path: not configured
Default path: active
Next hop: 123.123.123.2
Last label FSM state change time: 00:21:25
Targeted Hello: 1.1.1.1(LDP Id) -> 2.2.2.2, LDP is UP
Graceful restart: configured and not enabled
Non stop routing: not configured and not enabled
Status TLV support (local/remote)
LDP route watch
Label/status state machine
Last local dataplane
Last BFD dataplane
Last BFD peer monitor
Last local AC circuit status rcvd: No fault
Last local AC circuit status sent: No fault
Last local PW i/f circ status rcvd: No fault
Last local LDP TLV
Last remote LDP TLV
Last remote LDP ADJ
MPLS VC labels: local 577, remote 650
Group ID: local 238, remote 276
MTU: local 0, remote 0
Remote interface description:
SSM segment/switch IDs: 6893171/4140658 (used), PWID: 674
transit packet totals: receive 0, send 0
transit byte totals: receive 0, send 0
transit packet drops: receive 0, seq error 0, send 0
Configuring T1/E1 Interfaces on 48-Port T1/E1 Interface Module
Dest address
2.2.2.2
: enabled/supported
: enabled
: established, LruRru
status rcvd: No fault
status rcvd: Not sent
status rcvd: No fault
status sent: No fault
status rcvd: No fault
status rcvd: No fault
VC ID Status
10 UP