Required Equipment - Fluke 724 Calibration Manual

724/725
Calibration Manual

Required Equipment

Equipment and software required to perform the procedures in this manual are identified
in Table 5. If the recommended equipment model is not available, other equipment can
be substituted if it meets the specifications indicated.
To avoid safety hazards and equipment damage during the calibration
procedures, use the specified calibration equipment listed in Table 5.
Using unspecified equipment can give unreliable results and pose
safety hazards.
Equipment
Multi-Product Calibrator
MET/CAL ® Metrology
Software
(see MET/CAL
Installation and Upgrade
Guide for minimum
hardware requirements)
Digital Multimeter
Pressure Module
(725 only)
Test Leads
Thermocouple test lead
Personal computer
PC interface cable
(725 only)
Calibration cable
14
Warning
Table 5. Required Equipment and Software
Minimum Specifications
DC voltage: 0 V to 30 V
Accuracy: ±0.005 %
DC current: 0 mA to 24 mA
Accuracy: ±0.005 %
Temperature: Type J thermocouple
90 day accuracy: ±0.2 °C
Resistance accuracy: ±0.006 %
Frequency accuracy: ±0.01 %
Version 6.0 or later
DC voltage: 0 V to 24 V
Accuracy: ±0.0013 %
DC voltage: 0 mA to 24 mA
Accuracy: ±0.005 %
In working condition; for establishing
communication only
Two sets of stackable banana test
leads
2 type J male miniplugs with ~12"
(30.5 cm) of 20-gauge type J
thermocouple wire
Windows ® 3.1 or later with terminal
communication software
Fluke 700SC serial interface cable
assembly (LEMO to DB-9 female)
Fluke 724/725 Calibration Cable
Recommended Model
Fluke Model 5520A Multi-Product
Calibrator only− no substitute
Contact Fluke for the latest version.
HP 3458A only− no substitute
Fluke 700PXX Series
2 red leads: Fluke PN 105809
2 black leads: Fluke PN 105806
Fluke Model 80CJ-M male miniplugs
(package of two)
20-gauge type J thermocouple wire is
available through an electronic
supply outlet
486 (or later) IBM-compatible
Fluke PN 667425
Fluke PN 1556747