Easy Setup; Calibration And Sensor Setup - ABB Aztec AWT440 Commissioning Instructions

5

Easy setup

When the transmitter is started up for the first time, the 'Easy
Setup' prompt is displayed:
AWT 440
New TX
Detected
Start Easy
Setup ?
Press the key ( ) to start Easy Setup or press the
( ) to cancel and exit to the main Operator page.
Transmitter parameters that can be configured using Easy Setup
are shown on the left side of the screen and the factory default
value / setting for each parameter is shown on the right.
Press the key (Edit) to change the default value / setting to
the required value / selection. Press the
accept the default or revised value /selection and advance to
the next parameter.
Transmitter parameters that can be configured in this way are:
Language, Instrument Tag, Diagnostics View, Signals View,
Chart View, Alarm View, Analog OP View, Calibration Log, Alarm
Log, Audit Log, Diagnostics Log, Date Format and Date & Time.
On completion of Easy Setup, the display returns to the 'Easy
Setup' start screen:
Menu
Easy Setup
Exit Select
Press the key (Select) to revise / amend the settings just
made or press the key (Exit) to cancel and exit to the main
Operator page.
All transmitter parameters can be revised / changed at any time
by selecting Enter Configuration from any Operator or View page
menu, followed by Advanced from the Access Level menu.
IMPORTANT (NOTE)
– If 'Easy Setup' does not detect a keypress within
5 minutes, the display changes automatically to the
main Operator page.
– Refer to Section 7, page 11, for details of menu
navigation and parameter selection / adjustment.
10
6
Calibration and sensor setup are sensor-specific – refer to the
relevant sensor Operating instruction to perform a calibration
and setup the sensor.
key
Ensure all electrical connections have been made correctly and
switch on the power to the transmitter. If the sensor is being
commissioned for the first time, sensor calibration and set-up is
recommended for best results.
key (Next) to

Calibration and sensor setup

CAUTION – Minor injuries
Do not attempt to setup the transmitter unless the
sensor and transmitter are fully installed and ready for
operation.
CI/AWT440–EN Rev. A